Horizontal Grinders For Sale

Needs an infeed chain and probably sprockets. Needs stacker belt. Extra mill and feed wheel available.  Otherwise, runs good. We have bigger grinders available and we don’t need to put any money into this one.

UPDATE 3-17-21:This was a decent runner for us until we hit something or a screen let loose. We don’t use it enough to justify us putting any money into it. (The more we looked at it, we decided to start fixing it. It looked much worse than it was.) We estimated around $10-15k to fix … Continue reading “1999 Morbark 5237”

Good running MC266. We’ve had it several years. Bottom end of engine redone within last 400 hours. Newer mill, mill bearings and infeed bed.  Magnet. Remote. Reversing fan. (Crossbelt magnet is available but NOT included.) Wire harness was updated. Originally plumbed for color pump but the infrastructure is no longer there. It could be put … Continue reading “2008 Rotochopper MC266”

Best value in a land clearing or mulch grinder! Price reduced. Almost brand new infeed table ($40k+), mill has been refreshed with pockets and hammers. Mill had been kept up with criss cross surfacing.  PT Tech, Remote, Reversing Fan, Magnet…Runs great. We’re running bigger track units now so we don’t need this one.

Is a good runner for us. Newer stacking belt in 2021, feed wheel in ’17,  wiring harnesses updated…Kept it up because we had to use it. Magnet, reversing fan and working remote control included. 4 in and 5 in square screens. This early version uses one screen at a time, not two like the newer … Continue reading “2004 Vermeer HG6000”

We bought it to grind cardboard cores but we decided not to bring it inside our building. Therefore, we’re shifting gears on that part of our business. This was probably sold as a ’14 unit. We believe the engine was replaced or rebuilt at some point because the engine hours are around 1500.  7600 rotor … Continue reading “2013 Rotochopper MC266B”

This is a very well taken care of, one owner CBI. All maintenance is done in house and done to CBI standards if not better. We have been in the grinding business for over 20 years and we go beyond manufactures standards. Remote, reversing fan, Twin Disc clutch, down swing rotor. New injectors in 2019. … Continue reading “1998 CBI 4800”

Second owner. We’re pretty sure there are several hours of “not under load” run time from the previous owner. They would start it in the morning and load a little throughout the day.  Owned it for about four years. The lower bearings were done a while back in the engine because we had a leak … Continue reading “2017 Rotochopper MC266”

Would trade for a track Peterson, including a little bit of a project. Upgraded panel and remote control. Newer mill bearing on the clutch side. Magnet and Reversing Fan.  Runs good. Come and check it out. Roadworthy. We move it often. Contact us for a short video.

Out of frame Engine rebuild $59,000.  Remote Control. Magnetic Head Pulley. Overband Magnet. New Radiator. New steel infeed belt. New PTO pump motor. All cylinders repacked and many new hydraulic lines. Purged all tanks and replaced fluids. This does not have a color pump or spray bar.) New tires all around. Various screens. Was inside … Continue reading “2005 Rotochopper MC-266”