FILTER
HPTO Clutch. Newer: clutch bearings, several hydraulic hoses, drive belts, clutch drive pulley, belly belt, etc. Reworked the middle six augers under the mill. Ready to run. Lights are good. Cross Belt Magnet is NOT included. Video on Facebook: https://www.facebook.com/GrinderTrader/videos/319543139139346/
Raker mill, Remote, Magnet. Mill is decent. This does not have a standard clutch like most people know clutches. It has a belt tensioner to engage the mill. Works about three times a week. Will do small green waste, slabs, pallets, bark, etc. One pass sizing is possible. No Def fluid required. 2 3/4″ square … Continue reading “2014 Rotochopper MC266”
Horsepower is estimated. Magnet. Remote. Reversing fan. Good grinder for the money. Should do well in green waste, pallets, small tree tops, slabs and saw mill waste, etc.
Nice, late model Chip Processor. Size and color mulch the easy way. We’re just not using this CP118. Your basic unit with magnet. Ready to regrind. It needs a bath but real busy right now.
Refurbished in 2016 by factory. Used less than 400 hours since refurbished. Everything was brought up to spec at that time. 28 tooth rotor, remote control, magnet and slab ramp. PT Tech clutch. Noise reduction muffler. Reversing fan. Optional skid mount colorizer included. (Will sell colorizer separate.) Excellent condition.
Good running small, horizontal grinder. Approximately early to mid 2000 model year. Magnet. New conveyor infeed belt. Teeth are good. Complete service last year. Lights and brakes work. We believe all safety switches are functioning correctly. Stacking conveyor transports in a position under the infeed hopper and engine. Hours may be accurate but unconfirmed. Can … Continue reading “2002 Concept Products D5600 Shred All”
Great running grinder. Working every day, come watch it run! 7,654 hours with meticulous maintenance and upkeep. 600 hours ago – new PT Tech clutch and PTO pumps, new Mill bearings, new compression cylinders, new control board, new remote, new grease lines, new paint job. 300 hours ago – new discharge belt, new skirting, 8 … Continue reading “2005 Peterson Pacific 4700”
Was $349,900. Great maintenance but does need two upgrades. Runs well. It has remote control, magnetic head pulley. Roadworthy. The holders on the mill need redone and balanced. The replaceable infeed bed has several cracked slats.
Video: https://www.facebook.com/GrinderTrader $159,900! Nice, low hour horizontal grinder. Grinder saw little use. Hours are around 500 or so. Certified CAT engine. Decent horsepower. New clutch. Magnet and Remote. Pics are current. Video available on FaceBook.
Good hours. Runs well. Magnetic Head Pulley and Reversing Fan. Impact Release System. PT Tech clutch. New Banana Bars in mill. Compressor. Several Screens included.
