Horizontal Grinders For Sale

Good running MC266. We’ve had it several years. Bottom end of engine redone within last 400 hours. Newer mill, mill bearings and infeed bed.  Magnet. Remote. Reversing fan. (Crossbelt magnet is available but NOT included.) Wire harness was updated. Originally plumbed for color pump but the infrastructure is no longer there. It could be put … Continue reading “2008 Rotochopper MC266”

Best value in a land clearing or mulch grinder! Price reduced. Almost brand new infeed table ($40k+), mill has been refreshed with pockets and hammers. Mill had been kept up with criss cross surfacing.  PT Tech, Remote, Reversing Fan, Magnet…Runs great. We’re running bigger track units now so we don’t need this one.

A pair of RG1’s. Enough here to make a good one. 2013: Rotochopper RG1 asphalt roofing shingles grinder for parts or repair. An excavator got in a fight with the upper feed auger. We decided not to repair it and use some parts off of it. Has a Cat c18 with 6,000 hrs, some parts missing … Continue reading “2013 Rotochopper RG1”

Is a good runner for us. Newer stacking belt in 2021, feed wheel in ’17,  wiring harnesses updated…Kept it up because we had to use it. Magnet, reversing fan and working remote control included. 4 in and 5 in square screens. This early version uses one screen at a time, not two like the newer … Continue reading “2004 Vermeer HG6000”

This is a very well taken care of, one owner CBI. All maintenance is done in house and done to CBI standards if not better. We have been in the grinding business for over 20 years and we go beyond manufactures standards. Remote, reversing fan, Twin Disc clutch, down swing rotor. New injectors in 2019. … Continue reading “1998 CBI 4800”

Second owner. We’re pretty sure there are several hours of “not under load” run time from the previous owner. They would start it in the morning and load a little throughout the day.  Owned it for about four years. The lower bearings were done a while back in the engine because we had a leak … Continue reading “2017 Rotochopper MC266”

Would trade for a track Peterson, including a little bit of a project. Upgraded panel and remote control. Newer mill bearing on the clutch side. Magnet and Reversing Fan.  Runs good. Come and check it out. Roadworthy. We move it often. Contact us for a short video.

Out of frame Engine rebuild $59,000.  Remote Control. Magnetic Head Pulley. Overband Magnet. New Radiator. New steel infeed belt. New PTO pump motor. All cylinders repacked and many new hydraulic lines. Purged all tanks and replaced fluids. This does not have a color pump or spray bar.) New tires all around. Various screens. Was inside … Continue reading “2005 Rotochopper MC-266”

A lot has been redone on this grinder. Runs well. Good hours. Overband (cross belt) magnet. Great little pallet grinder with no compromises. Light green waste or small cedar trees in Texas is no match. Pintle tow, single axle. We should get more pics listed soon. Call with specific questions and we’ll make sure you … Continue reading “2013 Rotochopper MP2”

New electronics, new transmision, rebuilt starters, completely checked out by CBI mechanics and is in excellent running order and ready to work. Mill has been refreshed with pockets, teeth…Reversing fan, remote control, magnet and metal detection. Owned by one guy for about the first 14 years.  As you can see the grinder shows well and … Continue reading “2001 CBI Magnum Force 4000”