Several updates to this grinder in the last few years. Currently being used daily on mulch yard. In the last few years: mill box redone, mill refreshed, rebuilt grapple (a valve is on order), auger shafts, belts, etc. Cotter box and clutch are good. 5-6 good screens included along with a few other wear parts. … Continue reading “1995 Morbark 1300WCL”
Morbark Grinders For Sale
Morbark offers the widest array of tub grinders, horizontal grinders and wood shredders of any manufacturer. 2017 marks 60 years of manufacturing equipment for sawmills, wood waste recycling, landclearing and wood processing. If you need a tough grinder, consider used Morbark grinders.
Good solid unit, clean. We believe 1400 hours is accurate. Grapple was removed years ago. No remote- the receiver is on the grinder. MAGNET. Includes approx. 38′ stacking conveyor. Ran roughly 2000 yards of pine mill waste. Several sets of screens. (Chip thrower blower housing and wheel is there with approx. 70% of parts are … Continue reading “1997 Morbark 1050”
Factory refurbished about 1,000 hours ago. Remote control included. Has short conveyor with hard-to-find chip thrower. No magnet. Nice dual axles and fifth wheel (also hard to find). Swinging hammers. 2″ and 3″ sets of square screens. The refurb was more than a few years ago. Not many hours since the refurb. Ready to work.
Platinum CAT warranty at 6,000 hours. Includes spray bar and Spitfire coloring system. No loader so all the power goes to the mill. Basic wear parts need updated and it could use paint. Engine runs great. Willing to consider offers.
This horizontal grinder was rebuilt from front to back, including CAT engine by CAT dealer, in 2016. Mill and bearing updates in 2017. Working remote control. NO Magnet. 8″ diameter rotor shaft and 48″ high feed opening. Twin Disc 318 clutch. Roadworthy and ready to run today. 6″, 1.5 and .375 included. Seller may lease … Continue reading “2001 Morbark 5600”
Motor has been overhauled. Newer Mill Shaft & Bearings. Radiator reconditioned. Heat and autofeed work great. Tight Grapple. Torque limiter and clutch in good shape. Magnet & tub cover. All new tires. 24 hammers. List of screens available.
New cat under carriage. Remote, Magnet, Torque Limiter, Proclain Drive, Reversing Fan and Air Compressor. New holders/tips, Conveyor Belts. Drag chain infeed. Used on one big job. Can demo.
Total rebuild on engine, clutch. Several new parts: turbo, hydraulic pump, tub drive, chain, sprockets, belts, almost all hydraulic hoses… Mill is in great shape. Won’t find a nicer one. Full list available. Will consider offers!
Remote, Reversing Fan, PT Tech Clutch, Dual Feed drives, Rod Puller, Air Compressor, Magnet. Recently had New Belly Belt and Feed Wheel Gear Box. Three Axles.
PT Tech clutch, torque limiter. Reverse pivot for longer materials. Poclain infeed drive (no gear box). Magnet, Remote Control. Options on screens.